The Adyen S1F2 terminal is a wireless countertop terminal for Quilt subsidiaries. This state-of-the-art card reader accepts chip, contactless NFC, or swipe and the attached thermal receipt printer makes taking transactions easier than ever.
Our credit card readers are plug-and-play; Simply connect it to a local Wi-Fi network, enter the pairing code, and start taking payments in minutes.
The S1F2 device is also low-maintenance with no additional upkeep required. Updates happen automatically using the Wi-Fi network with no interruptions and no hassle.
The terminal retails for $400 USD and $450 CAD though prices may vary so check with a supervisor for more detailed information.
To view the terminal’s parts and features, see the Castle S1F2 product sheet.
<aside> 💡 Note: This terminal only works for Merchants using Adyen. For Merchants on Stripe, they must use the WisePOS E terminal.
</aside>
https://lh6.googleusercontent.com/eL6I2xZGeMxQPXKzXgb3YNFezVCSEoWAVeOl4OlHNXhpzCV-XRkNkNTL1L2McppQJmvNJbZ1zbXuz5aWfMrHR8tgnzlQSTEvoFpmt5U_njop8k3vBfgEpjVFUt4Vn6GN8p7tkh_d-pJopmt9dPiYLyk
To load or replace the paper in the S1F2 terminal, grasp the cap (the top of the device with the Contactless icon) of the device on either side from the end and pull up away from paper output.
Next load the receipt paper face-down with the paper coming feeding out from the bottom.
Once the paper is loaded, close the lid and snap it into place.
<aside> 💡 Note: If the paper prints blank then swap the direction of the paper.
</aside>
If the payment terminal is turned on for the first time or after it was off for a long time, it may need to check for updates which can take 10 to 20 minutes.
<aside> 💡 Note: While the terminal is updating, the screen may flash or appear to turn off. Once the update is done, the screen should turn on.
</aside>
When the merchant first receives the device, it should come partially powered up. Use the supplied wall charger to begin charging the device to full power.
Once charged for at least 30 minutes, press and hold the power button until the display turns on. If necessary, connect the terminal to a power supply to charge the battery. Once the device is powered on, pressing the power button once will sleep/wake the device.