✨ Follow these steps to set up the Stripe WisePOS-E Card Reader.

Step 1: Powering Up the Device

• Install the Battery:
  • Remove the back cover by lifting it from the bottom left corner.
  • Insert the battery, ensuring the gold connectors align at the top.
• Charge the Reader:
  • Use the provided USB cable to connect to the port with the ⚡ lightning bolt symbol.
  • Note: A USB wall outlet is not included. Use a computer’s USB port or purchase a USB wall charger.
• Power On/Off:
  • Hold the power button (right side) until the screen turns on.
  • To fully power off, hold the power button and select Power Off on the screen.
  • 💡 Tip: Keep the device powered on and plugged in to receive automatic software updates.

Step 2: Connecting to WiFi

• Access WiFi Settings:
  • Swipe right from the left edge of the screen to open the Settings Menu.
  • Tap the Settings Button and enter the admin PIN: 07139.
• Select Your Network:
  • Tap Wi-Fi Settings.
  • Use the touchscreen to select your WiFi network and enter the password.
  • Return to the main menu by tapping the back arrow (top left).
• WiFi Requirements:
  • The network must use WPA-Personal or WPA2-Personal encryption and be password protected.
  • The WiFi network must match the one your registered computer is connected to.
  • If using Ethernet, hard-wire both the reader and computers for consistent connectivity.

Step 3: Pairing Your Device

• Generate a Pairing Code:
  • Open the Settings Menu (swipe right).
  • Enter the admin PIN: 07139.
  • Tap Generate Pairing Code.
• Follow Pairing Instructions:
  • Instructions vary by platform but are generally similar to Adyen processes.
  • Select WisePOS-E as the device during setup.
• Update the Device:
  • After pairing, the reader may prompt for a software update.
  • Start the update; this may take several minutes depending on network speed.

Step 4: Using the BBPOS WisePOS E Dock (Optional)

• Features:
  • Provides Ethernet connectivity and keeps the reader charged.
  • Includes rubber feet for stability and allows easy docking/undocking.
• Setup Instructions:
  • Connect the Ethernet cable to the dock and router.
  • Plug the dock into a power source (5V-2A minimum).
  • Insert the reader into the dock.